depot pull
Pay in 4 interest-free payments of $15.30 Learn more
Ships within 48 hours · Estimated delivery Sep 12 - Sep 17
verify the water flow rate and actual tank temperature before replacing the sensor
a 500-ohm resistor must be installed across the input terminals to convert the current signal to the appropriate voltage range
the porcelain insulator on the OEM flame sensor can develop microscopic cracks that require a full replacement
providing a rugged solution for high-ambient thermal monitoring
Broad Compatibility: Standard 1/4 inch spade terminals allow for seamless integration with existing control board lead wires
Laars Heating Systems T2017200 Tile 322056-301 verify the water flow rateThe Laars Heating Systems T2017200 Rear Center Tile is a critical replacement component for high output Laars Pennant boilers and volume water heaters. Designed specifically for the Pennant series, including models ranging from the 1250 to 2000 (both LP and NG configurations), this refractory tile serves as a focal point for heat management within the combustion chamber. By acting as high temperature insulation, the Laars T2017200 directs thermal